PYE CORNICE COMPOUND
For Fixing and Bonding Cornice
Gypsum-based adhesive applied to plasterboard walls and ceiling for fixing and bonding cornice. It can also be used for touching-up fibrous plaster boards to produce a seamless and precise finish by using a steel trowel
- Suitable for fixing and bonding cornice to wall and ceiling plaster boards.
- Product Code: FICO
- Packaging: 20 kg
Quick Selection Notes
- Use this when: You need PYE CORNICE COMPOUND to repair, seal, bond or protect a surface or component.
- User perspective: The maintenance user needs the product to match the material, surface condition and job method.
- Check before ordering: Confirm surface material, gap or damage size, curing time, exposure, finish and application method.
- Site fit: Match it to the substrate, exposure, application method and cleanup or inspection process.
- Ask Y K Toh to confirm: Share application photos, material type, surface condition, quantity and the result you need so the recommendation is sized around the real job.
Key Product Information
| Product Code | FICO |
|---|---|
| Colour | Off-White |
| Packaging | 20 kg |
| Cov.(app.) | Use as required |
Overview
Gypsum-based adhesive applied to plasterboard walls and ceiling for fixing and bonding cornice. It can also be used for touching-up fibrous plaster boards to produce a seamless and precise finish by using a steel trowel.
- Suitable for fixing and bonding cornice to wall and ceiling plaster boards.
Application
Mixing
- Use a container to fill with clean water.
- For required consistency of the mixture, simply sprinkle cornice compound into the later. The ratio is 2 or 3 parts of compound to 1 part water.
- Before mixing, soak the compound for 1 to 3 minutes.
- Over mixing is not encouraged as setting time of mixture could be sped up.
Application
- On the surface length of both edges of cornice, apply the mixture.
- To achieve a better result, simply press cornice into position until it holds.
- A broad knife is used to remove excess of compound.
- Use a damp sponge to clean off any residue.
- For bigger sized cornice it may need temporary support, for example, by using screws.
Cleaning of Equipment
Clean all tools and application equipment with clean water immediately after use. Hardened or cured material can only be removed mechanically.
Product Detail
Technical Information
| Colour | Off white |
| Form | Powder |
| Setting time | Approx. 30 minutes depending on the surrounding environment. |
| Adhesion | Very good bonding of cornice to plasterboard walls and ceilings. |
| Odour | Odourless when dry. |
| Coverage | Use as required. |
| Precaution | Do not over mix otherwise it will accelerate the setting time of the mixture. |
| Safety | Avoid contact with skin and eyes. Seek medical advice if swallowed. Keep out of reach of children. |
Â
Storage Conditions
Store properly in dry conditions, in undamaged and unopened, original sealed packaging. Keep away from direct sunlight, rain, water and moisture.
Principal Documents
Product information and image prepared from the PYE Products principal website. Source: PYE Products.
