PYE SILK-COAT
Silky Plaster Coat
A high quality, ready mixed acrylic copolymer resin based plaster coat. Suitable for use as a smooth plastered coat prior to painting for interior ceiling and walls
- Suitable for cement plaster.
- Used on previously painted walls.
- Product Code: FISC
- Packaging: 1.5 kg, 5 kg, 25 kg
Quick Selection Notes
- Use this when: You need PYE SILK-COAT to repair, seal, bond or protect a surface or component.
- User perspective: The maintenance user needs the product to match the material, surface condition and job method.
- Check before ordering: Confirm surface material, gap or damage size, curing time, exposure, finish and application method.
- Site fit: Match it to the substrate, exposure, application method and cleanup or inspection process.
- Ask Y K Toh to confirm: Share application photos, material type, surface condition, quantity and the result you need so the recommendation is sized around the real job.
Key Product Information
| Product Code | FISC |
|---|---|
| Colour | As per colour card |
| Packaging | 1.5 kg, 5 kg, 25 kg |
| Cov.(app.) | 0.5 m² / kg / mm |
Overview
A high quality, ready mixed acrylic copolymer resin based plaster coat. Suitable for use as a smooth plastered coat prior to painting for interior ceiling and walls.
- Suitable for cement plaster.
- Used on previously painted walls.
- Can be used on cement fiber board or precast panels.
Application
Ensure surfaces are clean, dry, free from grease and other impurities. Moisture content and pH of the surface applied should be below 8% and pH 9.5 respectively, remove old peeling paint works before applying.
Application
• Stir thoroughly before use. Add water and stir well if it is too dry.
• Apply approximately 0.5 – 1.5mm of PYE SILK-COAT as a plastered coat.
• Allow the coat to dry (dry time in normal temperature between 20°C – 30°C).
Touch dry : 15 min.
Hard dry : 2 hours
Full hard dry : 4 hours
Re-application interval : 2 hours if required.
• Sanding : after 5 hours (use sanding paper # 600 – 1000) only if required.
• For higher sheen, apply two coats of premium interior or exterior paint.
Cleaning of Equipment
Clean all tools and application equipment with clean water immediately after use. Hardened or cured material can only be removed mechanically.
Product Detail
Technical Information
| Adhesion | Adheres firmly to all surfaces which are clean, dry and grease free. Will not crack or fall out when dry. |
| Colour | As per colour card. |
| Coverage | Approximately 50 – 65sq.ft. per kg. |
| Drying time | A thin film dries in approximately 15 – 30mins when used for leveling irregular surfaces, drying time may vary depending on thickness. |
| Thickness | Apply approximately 0.5 – 1.5mm as a plaster coat before painting. |
| Sandability | PYE SILK-COAT has been formulated for easy sanding after 5 hours. |
| Odour | Odourless when dry. |
| Coverage | Approx. 1.5sq.m @ 16sq.ft./kg. |
Storage Conditions
Store properly in dry conditions, in undamaged and unopened, original sealed packaging. Keep away from direct sunlight, rain, water and moisture.
Principal Documents
Product information and image prepared from the PYE Products principal website. Source: PYE Products.
